|
|
|
Uh oh...
|
I unclamped the panels and found an indentation about a half inch long near one of the joints. My guess is that it was a piece of a shaving that got trapped underneath the panel before it was clamped for gluing. A good reminder about the importance of keeping a clean workplace.
I'm not sure what I'm going to do about this, if anything. I may just end up leaving it alone as it's on one of the keel panels, which will inevitably end up getting scratched up.
---
There is an ongoing discussion about this build in our forums in the "Boat and Accessory Building" section. If you have any questions or comments, please post them in the thread titled "Bear Mountain Enterprise - Building Q&A"
|
|
