|
|
|
An additional step
|
Because the shear clamp was glued to the hull early, I had to somehow at this stage, temporarily attach the deck to the hull for sanding and glassing. I cut small slots in the plastic on the shear clamp and will apply a small dab of hot glue to hold the deck in place. After the deck is fiberglassed, I'll use a putty knife to gently pry the hot glue loose. Note that I applied a small piece of tape below each glue location to aid in locating the exact spots to pry.
---
There is an ongoing discussion about this build in our forums in the "Boat and Accessory Building" section. If you have any questions or comments, please post them in the thread titled "Bear Mountain Enterprise - Building Q&A"
|
|
