BigandSmall
Paddler
Leave the 80 grit pigtails and epoxy fill right over top, will they disappear?
Or should I sand them all to 120 grit but slightly deeper into the weave? (I'd like to avoid this)
I'd like to add a thin top coat of epoxy after level sanding the kayak. Just starting to show the weave in a few too many locations for my liking, not into the weave but just appearing. My mouse sander left some deeper pigtails with the 80 grit I was using to level everything out. Since the boat is starting to look good I don't want to save time and ruin the finish. Thinking I'll heat the shop up for the top coat and after tipping off go over it with the heat gun to help get in in there.
Or should I sand them all to 120 grit but slightly deeper into the weave? (I'd like to avoid this)
I'd like to add a thin top coat of epoxy after level sanding the kayak. Just starting to show the weave in a few too many locations for my liking, not into the weave but just appearing. My mouse sander left some deeper pigtails with the 80 grit I was using to level everything out. Since the boat is starting to look good I don't want to save time and ruin the finish. Thinking I'll heat the shop up for the top coat and after tipping off go over it with the heat gun to help get in in there.